Datatek DT-6061 Manual do Utilizador descarregar pdf (Página 9)

'7717URXEOHVKRRWLQJ*XLGH

06/06/01 Datatek Applications Inc. 9

This is also a good time to use the

ver

command to verify that your are running the latest

UMI software build.

2.1.4

UMI - Node Side (“SAM 504”)

This part of the exercise confirms that the correct “SAM 504” ports (as the BNS-2000

node controller views the UMI virtual ports) are set up with a pre-defined destination

(PDD) corresponding to the BHI module. Refer to Appendix A, which contains a

conversion table from the

UMI User’s Manual

showing the UMI virtual port to SAM504

board/port mapping. Based on the virtual port assignments indicated in the UMI

vfy

vport all

report in the previous section, all 32 ports on “board 1 of the SAM 504” are

being used, and each needs to have a correctly-administered PDD (“host26” in the

example being used). In addition, the port type must be “term”, and the protocol must be

“bisync”.

From the node console, use the

vfy sam p <mod#> <board#> <port#>

to display the

configuration. Use

ch sam p

to change settings if necessary.

CC0> vfy sam p 19 1 2

01-05-08 14:58:57 NODE=WOODY

M verify sam port 19 1 2

MODULE ADDRESS: 19

MODULE TYPE: sam504 NCHLS: 512

SERVICE STATE: in SECS BEFORE DISCONNECT: 50

TRUNK TYPE: t1 LINE SPEED: 1.544M

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sem comentários

Datatek DT-6061 Manual do Utilizador Página 9