Datatek DT-6061 Manual do Utilizador descarregar pdf (Página 8)

'7717URXEOHVKRRWLQJ*XLGH

06/06/01 Datatek Applications Inc. 8

Make sure the module is in service and the

Local IP Address

indicated in this report

agrees with the

BiSync Host Interface

(IP address part) from the TN3270 Application

report in the previous section.

Now use the

vfy vport all

command to check the UMI virtual port settings:

<UMI> vfy vport all

Virtual Ports 1 - 32 :

Type ==> TCP Port 31000 w/Call Listen.

Service State ==> In Service.

Protocol ==> Synchronous.

Virtual Ports 33 - 504 :

Type ==> TCP Port 12345 w/Call Listen.

Service State ==> Out of Service.

Protocol ==> Synchronous.

There should be a group of receive-type virtual ports (indicated by “Call Listen”) using a

TCP port number which agrees with the

BiSync Host Interface

(port number part) from

the TN3270 Application report in the previous section. The protocol must be

synchronous and the virtual port group must be in service. Use the

vport

command to

change settings if needed. (If the virtual ports are not in service, they must be put in

service using

restore sam

on the BNS-2000 node. Refer to the

UMI User’s Manual

)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sem comentários

Datatek DT-6061 Manual do Utilizador Página 8