Datatek IPv6 Transformer Quick Start Guide Manual do Utilizador Página 1

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com 6. Configure Static Routes (if using an IPv6 router) Select the System: Static routes l

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com For the Protocol, select IPv6, and for the Destination, enter the word default. For the

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com This will bring you back to the System: Static routes page. Select Apply Changes to save

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com 7. Reboot The configuration changes we made on the System: Interface Setup page requir

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com 1. Connect Transformer It is recommended to connect the IPv4 Host-Side Device with a

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com 2. Network examples In our example network, Figure 1-2 shows the actual IPv4 and IPv6

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com IPv6IPv42008::100:2192.168.1.992008::100:1192.168.1.98IPv4 Perspective192.168.1.2 Figure

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com 2. Configure IPv4 and IPv6 Interfaces from serial port Most of the Transformer configura

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com 3. Connect to webGUI Start a web browser program on the IPv4-only host, like Internet E

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com 4. Configure Host-side Device IP Along the left-hand side of every webGUI page, there is

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com 5. Configure Static Address Map Here we will configure Static IPv6 to IPv6 address mappi

IPv4-IPv6 Transformer Quick Start Guide www.datatekcorp.com Enter the IPv4 and IPv6 addresses as shown in Fig 1-3. From the IPv4 legacy device’s per